Rest assured that you have no obligation to purchase the product once you know the price. The low-cut filter eliminates turntable noise and “skipping” in high-traffic areas by filtering out deep bass. We’ve never lost the motivation that comes with the development of developing technologies over the previous four decades, and we appreciate you, as well as the thousands of ART users, for your continuous support and commitment. Gemtracks gives you priority access to exclusive A-Class recording studios around the world. Compared to 1999, the average music consumer was under 30 and spent $28 a year. We are also available on a case-by-case basis to run sound for live venues, bands, and events.

m composer

  • This is an efficient method to transfer your vinyl collection onto your computer, and the audio quality is surprisingly good for a low-cost gadget.
  • On the right there’s a three-way toggle for monitor source, a headphone jack and another, smaller dial for output level.
  • This device does have one thing in common with other less expensive tube devices.
  • Not much to ask for other than a nicer looking enclosure in a future revision.
  • That the stock Pro VLA sounds so good is a testament to how smart the electrical design is – even though the components are not that great, it still sounds pretty damn good!
  • A six-section, stereo LED ladder meter follows either the left/right levels or the aux send, and there are further buttons to route the USB return to the Control Room feed or, pre-fader, to the Main Mix.

This preamp is much better quality than those in the mixer we were using. Yes there is a learning curve to finding the “sweet spot” for the sound you like but it’s worth it. We are getting serious about our audio quality and use large condenser mics and dynamic mics for a lot of our audio work. My unit doesn’t seem to be very accurate as far as output goes. There is a big difference between the output of the two channels, so you have to do a lot of tweaking to get the levels matched. When the levels are matched on the unit, the output of the two channels is Very different.

Art Pro Audio Pro Vla Ii By Kyzer

I was astounded at how good this thing sounds as opposed to how cheap it is. The PRO VLA is kind of a poor man’s LA-2A, and would be a great first compressor for anyone. Art’s Pro VLA II is a tube driven vactrol based compressor / limiter which has gained quite a reputation on these forums.

Problem Solved!

There are also ‘Aux Send to Control Room’ and ‘Main to Control Room’ routing buttons. Useful extra features, such as variable input impedance and M/S decoding. The Pro MPA2 can be set up for dual‑mono, conventional stereo or M/S (Mid/Side) operation.

The stylus introduces huge mismatch in comparison and this is the point where i would like this dealt with. The rear panel of the MPA Pro2 sports balanced analogue inputs and outputs, and +4dBU/-10dBV switching. The Power Base 4×4 features ART’s “4×4” distribution on the back of the unit — four of the eight rear outputs are 1.25 inches apart. This allows the user to plug in wide power cables and multiple…

It had a pretty good overall sound quality on the sources I recorded. Due to the other material recorded not yet being release I could only provide examples of the guitar track presented here. While it would not be my first choice of pre, with a couple of higher end options being my go-to’s, it would always be a consideration. The combination of an expansive feature set and a low price point make this a no brainer for anyone looking into an inexpensive pre.

Restoring The “holy Grail Of Compressors”: Behind The Scenes At The Vintage King Tech Shop

At modest drive levels, this can be useful in bolstering a weak vocal, but I’m not a fan of vocals driven to the point where the distortion is obvious, so probably wouldn’t venture much more than halfway up the drive LED meter. This degree of drive would probably only be used on certain instruments, or maybe as an obvious effect on some pop and urban vocal styles. The ART DJPRE II phono preamplifier (formerly named the “Phono MicroPRE”) acts as an interface between your turntable and your audio recording / playback system. The Art HP-1 is a belt-worn; battery-powered headphone amplifier that brings excellent performance to portable applications. With a locking 1/4″/XLR Combo input jack, sturdy belt clip, and output volume control, it provides reliable performance both on and off the stage.

Art Tube Mix

As a home studio for ourselves & our friends, I can’t foresee us upgrading anytime soon. I know there’s a lot of love for this unit but in my experience it offers too little of a real improvement in the sound. If you’re buying something for the tube sound, you might get a 5% improvement. Over all, you get what you pay for, but I suggest saving up for a UA Solo 610 or a Grace Design or whatever. It’s worth the extra few $$$ over this price range of preamps.